Obliczenia projektowe gruntowych wymienników ciepła pomp ciepła
Authors:
- Wojciech Zalewski
Abstract
The aim of the paper to present the computational algorithms for vertical ground exchangers, run the examples of design calculations that consist of determining the depth of boreholes (the length of tubes) and compare the calculation results obtained with the applied algorithms. Two methods based on the Bose et al. model and the ASHRAE model were used during the calculations. They pertain to the single U-tube type exchanger for either one, three or six tubes in a loop. The calculation results of the length of tubes (the depth of boreholes) obtained with both methods are not fundamentally different. Greater depths of boreholes, and thus lower heat flow rate intensity was achieved using the ASHRAE method. The percentage differences do not exceed 20%. Due to the greater universality of the Bose et al. model, it is recommended to use the calculation method based on this model in practice.
- Record ID
- CUT309ffce3183b42d584ba6760a6bb0ec1
- Publication categories
- ;
- Author
- Other language title versions
- Design calculations of ground heat exchangers of heat pumps
- Journal series
- Ciepłownictwo, Ogrzewnictwo, Wentylacja, ISSN 0137-3676, e-ISSN 2449-9900, Monthly
- Issue year
- 2019
- Vol
- 50
- No
- 1
- Pages
- 16-21
- Other elements of collation
- schem.; tab.; Bibliografia (na s.) - 21; Bibliografia (liczba pozycji) - 10; Oznaczenie streszczenia - Streszcz., Abstr.; Numeracja w czasopiśmie - T. 50, nr 1
- Keywords in Polish
- pompa ciepła, gruntowy wymiennik ciepła, pionowy wymiennik ciepła, metody projektowania
- Keywords in English
- heat pump, ground heat exchanger, vertical heat exchanger, design methods
- Abstract in Polish
- Celem pracy jest przedstawienie algorytmów obliczeniowych pionowych wymienników gruntowych, przeprowadzenie przykładowych obliczeń projektowych polegających na wyznaczeniu głębokości odwiertów (długości sond) i porównanie wyników obliczeń otrzymanych zastosowanymi algorytmami. W obliczeniach wykorzystano dwie metody oparte na modelu Bosego i in. oraz na modelu ASHRAE, odnoszące się do wymienników typu pojedyncza U-rura dla jednej, trzech i sześciu sond w pętli. Otrzymane za pomocą obu metod wyniki obliczeń długości sond (głębokości odwiertów) nie różnią się zasadniczo między sobą. Większe głębokości odwiertów, a więc mniejsze gęstości strumienia pozyskiwanego z gruntu ciepła otrzymano stosując metodę ASHRAE. Różnice procentowe nie przekraczają 20%. Ze względu na większą uniwersalność modelu Bosego i in. zaleca się stosowanie w praktyce metody obliczeniowej opartej na tym modelu.
- DOI
- DOI:10.15199/9.2019.1.3 Opening in a new tab
- URL
- http://sigma-not.pl/publikacja-118179-2019-1.html Opening in a new tab
- Language
- pol (pl) Polish
- Score (nominal)
- 20
- Uniform Resource Identifier
- https://cris.pk.edu.pl/info/article/CUT309ffce3183b42d584ba6760a6bb0ec1/
- URN
urn:pkr-prod:CUT309ffce3183b42d584ba6760a6bb0ec1
* presented citation count is obtained through Internet information analysis, and it is close to the number calculated by the Publish or PerishOpening in a new tab system.